Asus TX97-X Bedienungsanleitung PDF herunterladen (Seite 22)

22 ASUS TX97-X User’s Manual

3. Central Processing Unit (CPU)

The motherboard provides a 321-pin ZIF Socket 7 that is backwards compatible

with ZIF Socket 5 processors. The CPU that came with the motherboard should

have a fan attached to it to prevent overheating. If this is not the case then purchase

a fan before you turn on your system. Apply thermal jelly to the CPU top and then

install the fan onto the CPU.

WARNING! Without a fan circulating air on the CPU and heat sinks, the CPU

and/or heat sinks can overheat and cause damage to both the CPU and the moth-

erboard. (See “CPU Cooling Fan Connector” at the end of this section.)

To install a CPU, first turn off your system and remove its cover. Locate the ZIF

socket and open it by first pulling the lever sideways away from the socket then

upwards to a 90-degree right angle. Insert the CPU with the correct orientation as

shown. Use the notched corner of the CPU as your guide. The white dot should

point towards the end the of the lever. Notice that there is a blank area where one

hole is missing from that corner of the square array of pin holes and a “1” printed on

the motherboard next to that corner. Because the CPU has a corner pin for three of

the four corners, the CPU will only fit in the one orientation as shown. The picture

is for reference only; you should have a CPU fan that will cover the face of the CPU.

With the added weight of the CPU fan, no force is required to insert the CPU. Once

completely inserted, hold down on the fan and close the socket’s lever.

IMPORTANT: You must set jumpers for “CPU to BUS Frequency Ratio” and

jumpers for “BUS Frequency Selection” depending on the CPU that you install.

ZIF Socket 7 with Pentium MMX Processor

BlankLever Lock

Notch

III. INSTALLATION

(System Processor)

III. INSTALLATION

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 79 80

Keine Kommentare

Asus TX97-X Bedienungsanleitung Seite 22