Asus RS120-E5 PA2 Betriebsanweisung PDF herunterladen (Seite 58)

Chapter 4: Motherboard information4-8

4.3 Connectors

1. Floppy disk drive connector (34-1 pin FLOPPY1)

This connector is for the provided oppy disk drive (FDD) signal cable. Insert

one end of the cable to this connector, then connect the other end to the

signal connector at the back of the oppy disk drive.

2. IDE connector (40-1 pin PRI_IDE1)

This connector is for an Ultra ATA 100/66/33 signal cable. By default, this

connector supports the optical disk drive. You must congure the optical drive

as master/slave device by setting its jumper accordingly. Refer to the optical

disk drive documentation for the jumper settings.

Pin 5 on the connector is removed to prevent incorrect cable connection when

using a FDD cable with a covered Pin 5.

Pin 20 on the IDE connectors is removed to match the covered hole on the Ultra

ATA cable connector. This prevents incorrect insertion when you connect the

IDE cable.

P5BV-R

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

P5BV-R Floppy disk drive connector

FLOPPY1

PIN 1

P5BV-R

P5BV-R IDE connector

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE1

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 155 156

Keine Kommentare

Asus RS120-E5 PA2 Betriebsanweisung Seite 58