Asus M3A79-T Deluxe Bedienungsanleitung PDF herunterladen (Seite 61)

ASUS M3A79-T Deluxe

2-35

2.9 Starting up for the rst time

1. After making all the connections, replace the system case cover.

2. Be sure that all switches are off.

3. Connect the power cord to the power connector at the back of the system

chassis.

4. Connect the power cord to a power outlet that is equipped with a surge

protector.

5. Turn on the devices in the following order:

a. Monitor

b. External SCSI devices (starting with the last device on the chain)

c. System power

6. After applying power, the system power LED on the system front panel case

lights up. For systems with ATX power supplies, the system LED lights up

when you press the ATX power button. If your monitor complies with “green”

standards or if it has a “power standby” feature, the monitor LED may light up

or switch between orange and green after the system LED turns on.

The system then runs the power-on self tests or POST. While the tests are

running, the BIOS beeps (see BIOS beep codes table below) or additional

messages appear on the screen. If you do not see anything within 30

seconds from the time you turned on the power, the system may have failed

a power-on test. Check the jumper settings and connections or call your

retailer for assistance.

BIOS beep codes

BIOS Beep Description

One short beep No keyboard detected

One continuous beep followed by two short

beeps then a pause (repeated)

No memory detected

One continuous beep followed by three

short beeps

No VGA detected

One continuous beep followed by four

short beeps

Hardware component failure

7. At power on, hold down the <Delete> key to enter the BIOS Setup. Follow the

instructions in Chapter 3.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 163 164

Keine Kommentare

Asus M3A79-T Deluxe Bedienungsanleitung Seite 61