Asus V3-M2V890 Bedienungsanleitung PDF herunterladen (Seite 36)

2-18 Chapter 2: Basic installation

2.9 Installingaoppydiskdrive

The V-Series M2V890 Barebone system comes with one 3.25-inch drive

bay for a oppy disk drive.

To install a oppy disk drive:

1. Remove the front panel cover.

For instructions on how to remove the front panel cover, refer to page

2-3 of section “2.3 Removing the side cover and front panel assembly”.

2. Carefully insert the oppy disk drive into the oppy drive bay until the

screw holes align with the holes on the bay.

3. Secure the oppy disk drive with two screws on both sides.

4. Connect the oppy disk drive signal cable to the signal connector at

the back of the drive.

5. Connect the other end of the signal cable to the oppy disk drive

connector on the motherboard. See page 4-4 for the location of the

oppy disk drive connector.

6. Connect a 4-pin power cable from the power supply unit to the power

connector at the back of the oppy disk drive.

Floppy ribbon

cable

Power cable

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 89 90

Keine Kommentare

Asus V3-M2V890 Bedienungsanleitung Seite 36