Asus RS100-E4/PI2 Bedienungsanleitung PDF herunterladen (Seite 101)

ASUS RS100-E4/PI2 6-3

6.1.2 Installing Serial ATA hard disks

The motherboard supports Serial ATA hard disk drives. For optimal

performance, install identical drives of the same model and capacity when

creating a disk array.

To install the SATA hard disks for a RAID conguration:

1. Install the SATA hard disks into the drive bays.

2. Connect the SATA signal cables.

3. Connect a SATA power cable to the power connector on each drive.

6.1.3 Setting the RAID item in BIOS

You must set the RAID item in the BIOS Setup before you can create a RAID

set(s). To do this:

1. Enter the BIOS Setup during POST.

2. Go to the Main Menu, select IDE Conguration, then press <Enter>.

3. Select the item Congure SATA As, then press <Enter> to display the

conguration options.

4. Select RAID from the Congure SATA As item options, then press

<Enter>.

5. Select the item Onboard Serial-ATA BOOTROM, press <Enter>, then

select Enabled from the options.

6. Save your changes, then exit the BIOS Setup.

Refer to Chapter 4 for details on entering and navigating through the

BIOS Setup.

6.1.4 RAID configuration utility

Depending on the RAID_SEL1 jumper setting and the operating system, you

can select a utility to create a RAID set. Refer to section “2.6 Jumpers” for

details on the RAID_SEL1 jumper settings.

Use the Intel

Matrix Storage Manager to create a RAID 0 or RAID 1 set

under Windows

2000/2003 Server/XP operating system.

Use the LSI Logic Embedded SATA RAID Setup Utility to create a RAID 0 or

RAID 1 under Windows

2000/2003 Server or Red Hat

Enterprise ver. 3.0

operating system.

Refer to the succeeding sections for details on how to use the RAID

conguration utilities.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 155 156

Keine Kommentare

Asus RS100-E4/PI2 Bedienungsanleitung Seite 101