
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setup
2-62-6
2-62-6
2-6
2.1.52.1.5
2.1.52.1.5
2.1.5
Installing the air ductInstalling the air duct
Installing the air ductInstalling the air duct
Installing the air duct
To install the air duct:
1. Take note of the parts of the air duct that should match specific locations
inside the chassis.
Metal strips to fit theMetal strips to fit the
Metal strips to fit theMetal strips to fit the
Metal strips to fit the
plastic clips on the air ductplastic clips on the air duct
plastic clips on the air ductplastic clips on the air duct
plastic clips on the air duct
CPU heatsinksCPU heatsinks
CPU heatsinksCPU heatsinks
CPU heatsinks
2.1.42.1.4
2.1.42.1.4
2.1.4
Removing the air ductRemoving the air duct
Removing the air ductRemoving the air duct
Removing the air duct
To remove the air duct:
1. Carefully route the cables that
may interfere when removing the
air duct.
Be careful not to pull off or
break any cables while removing
the air duct.
2. Hold the rear part of the air duct
and press it for about a fraction
of an inch, just enough to tilt the
front end.
3. When tilted, carefully pull the air
duct upward to release it from the
chassis.
Plastic clips to grip thePlastic clips to grip the
Plastic clips to grip thePlastic clips to grip the
Plastic clips to grip the
metal strips on the fan cagemetal strips on the fan cage
metal strips on the fan cagemetal strips on the fan cage
metal strips on the fan cage
Flat rubber pad should matchFlat rubber pad should match
Flat rubber pad should matchFlat rubber pad should match
Flat rubber pad should match
the top of the two heatsinksthe top of the two heatsinks
the top of the two heatsinksthe top of the two heatsinks
the top of the two heatsinks
Kommentare zu diesen Handbüchern