Asus RS260-E3/RS8 Bedienungsanleitung PDF herunterladen (Seite 40)

Chapter 2: Hardware setupChapter 2: Hardware setup

Chapter 2: Hardware setup

2-202-20

2-20

5. Remove the metal cover opposite

the PCI-X slot that you want to

use, then install a PCI-X card as

shown. The card golden

connectors should match the

notches on the slot.

6. Firmly push down the card until it

is completely seated on the slot.

7. Secure the card bracket with a

screw.

8. Connect power or signal cable(s)

to the card, if applicable.

Repeat steps 5 to 8 if you wish to install other PCI-X cards.

• Install PCI-X cards in the following order:

First PCI-X card – top slot (furthest from motherboard)

Second PCI-X card – middle slot

Third PCI-X card – bottom slot (nearest the motherboard)

Exceptions:

1. Install a RAID card to the top slot to facilitate connection of SCSI

cables.

2. Install a LAN card to the bottom slot for easy connection of LAN

(RJ-45) cables from the chassis rear panel.

• The PCI-X frequency depends on the number of cards installed on

the PCI cage. Refer to the table below for details.

Important notes on installing PCI cards in the PCI cageImportant notes on installing PCI cards in the PCI cage

Important notes on installing PCI cards in the PCI cage

Installed PCI-X cardsInstalled PCI-X cards

Installed PCI-X cards

PCI FrequencyPCI Frequency

PCI Frequency

One 133 MHz

Two 100 MHz

Dual-channel 66 MHz

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 175 176

Keine Kommentare

Asus RS260-E3/RS8 Bedienungsanleitung Seite 40