Asus Vintage Bedienungsanleitung PDF herunterladen (Seite 48)

Chapter 4: Motherboard information

4.4 Connectors

This section describes and illustrates the connectors on the motherboard.

See page 14 for the description of rear panel connectors.

1. IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra

DMA 100/66 signal cable has three connectors: a blue connector for

the primary IDE connector on the motherboard, a black connector for

an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),

and a gray connector for an Ultra DMA 100/66 IDE master device

(hard disk drive). If you install two hard disk drives, you must

configure the second drive as a slave device by setting its jumper

accordingly. Refer to the hard disk documentation for the jumper

settings.

• Pin 20 on the IDE connector is removed to match the covered hole on

the Ultra ATA cable connector. This prevents incorrect orientation

when you connect the cables.

• For Ultra ATA/133 IDE devices, use an 80-conductor IDE cable.

P4S800-MX IDE connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

SEC_IDE1

PRI_IDE1

PIN 1

AD1888

CODEC

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 85 86

Keine Kommentare

Asus Vintage Bedienungsanleitung Seite 48